Cisco Asr 9000 Series Aggregation Services Router Modular Quality Of Service Configuration Guide, Release - Cisco ASR 9000 Series Configuration Manual

Configuring Class-based Unconditional Packet Marking
Command or Action
Step 9 set mpls experimental {imposition | topmost}
exp-value
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)#
set mpls experimental imposition 3
Step 10 set srp-priority priority-value
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)#
set srp-priority 3
Step 11 set discard-class discard-class-value
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)#
set discard-class 3
Step 12
set atm-clp
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)#
set atm-clp
Step 13
exit
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)#
exit
Step 14
exit
Example:
RP/0/RSP0/CPU0:router(config-pmap)# exit
Step 15
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
pos 0/2/0/0

Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release

6.1.x
146
Configuring Modular QoS Service Packet Classification
Purpose
• For Layer 3 interfaces, the set cos command:
Is ignored on ingress policies on a main interface.
Is rejected on ingress policies on a subinterface.
Is supported on egress policies on main interfaces and
subinterfaces.
Sets the experimental value of the MPLS packet top-most or
imposition labels.
The imposition keyword can be used only in service policies
Note
that are attached in the ingress policy.
Sets the spatial reuse protocol (SRP) priority value of an outgoing
packet.
This command can be used only in service policies that are
Note
attached in the output direction of an interface.
Sets the discard class on IP Version 4 (IPv4) or Multiprotocol Label
Switching (MPLS) packets.
This command can be used only in service policies that are
Note
attached in the ingress policy.
Sets the cell loss priority (CLP) bit.
Returns the router to policy map configuration mode.
Returns the router to global configuration mode.
Configures an interface and enters the interface configuration mode.