Table of Contents
Advertisement
Please note while programming:
An active radius compensation is canceled
by defining Cycle 10 and must therefore be
reprogrammed, if necessary.
After defining Cycle 10, you must move both axes of
the working plane to activate rotation for all axes.
Cycle parameters
Rotation: Enter the rotation angle in degrees (°).
Input range –360.000° to +360.000° (absolute or
incremental)
HEIDENHAIN | TNC 320 | User's manual for cycle programming | 9/2016
ROTATION (Cycle 10, DIN/ISO: G73) 10.6
NC blocks
12 CALL LBL 1
13 CYCL DEF 7.0 DATUM SHIFT
14 CYCL DEF 7.1 X+60
15 CYCL DEF 7.2 Y+40
16 CYCL DEF 10.0 ROTATION
17 CYCL DEF 10.1 ROT+35
18 CALL LBL 1
10
261
Advertisement
Table of Contents
