Table of Contents
Advertisement
CALIBRATE TS RADIUS OUTSIDE (Cycle 463, DIN/ISO: G463) 16.10
Please note while programming:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
Before a cycle definition you must have programmed
a tool call to define the touch probe axis.
The center offset can be determined only with a
suitable touch probe.
A measuring log is created automatically during
calibration. The log file is named TCHPRAUTO.html.
In order to be able to determine the ball-tip center
misalignment, the TNC needs to be specially
prepared by the machine manufacturer. The machine
manual provides further information.
The characteristic of whether and how your
touch probe can be oriented is already defined in
HEIDENHAIN touch probes. Other touch probes are
configured by the machine tool builder.
Q407 Radius of calibr. stud?: Diameter of the ring
gauge. Input range 0 to 99.9999
Q320 Set-up clearance? (incremental): Additional
distance between measuring point and ball tip.
Q320 is added to SET_UP in the touch probe table.
Input range 0 to 99999.9999
Q301 Move to clearance height (0/1)?: Definition
of how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
Q423 NUMBER OF PROBES? (absolute): Number of
measuring points on the diameter. Input range 0 to
8
Q380 Ref. angle in ref. axis? (absolute): Angle
between the reference axis of the working plane
and the first touch point. Input range 0 to 360.0000
HEIDENHAIN | TNC 320 | User's manual for cycle programming | 9/2016
NC blocks
5 TCH PROBE 463 TS CALIBRATION ON
STUD
Q407=+5
;STUD RADIUS
Q320=+0
;SET-UP CLEARANCE
Q301=+1
;MOVE TO CLEARANCE
Q423=+8
;NO. OF PROBE POINTS
Q380=+0
;REFERENCE ANGLE
16
441
Advertisement
Table of Contents
