Table of Contents
Advertisement
MEASURE HOLE OUTSIDE (Cycle 422, DIN/ISO: G422) 15.6
Q279 Tolerance for center 1st axis?: Permissible
position deviation in the reference axis of the
working plane. Input range 0 to 99999.9999
Q280 Tolerance for center 2nd axis?: Permissible
position deviation in the minor axis of the working
plane. Input range 0 to 99999.9999
Q281 Measuring log (0/1/2)?: Define whether the
TNC should create a measuring log:
0: Do not create a measuring log
1: Create a measuring log: The TNC saves the
file TCHPR422.TXT
TNC:\.
2: Interrupt program run and output measuring log
to the TNC screen. Resume program run with NC
Start.
Q309 PGM stop if tolerance exceeded?: Definition
of whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0: Do not interrupt program run, do not output an
error message
1: Interrupt program run and output an error
message
Q330 Tool for monitoring?: Definition of
whether the TNC is to monitor the tool (see "Tool
monitoring", page 380). Input range 0 to 32767 .9,
alternatively tool name with maximum of 16
characters
0: Monitoring inactive
>0: Tool number in the tool table TOOL.T
Q423 No. probe points in plane (4/3)?: Specify
whether the TNC should measure the stud with 4 or
3 probing points:
4: Use 4 measuring points (default setting)
3: Use 3 measuring points
HEIDENHAIN | TNC 320 | User's manual for cycle programming | 9/2016
as standard in the directory
Q281=1
Q309=0
Q330=0
Q423=4
Q365=1
log
;MEASURING LOG
;PGM STOP TOLERANCE
;TOOL
;NO. OF PROBE POINTS
;TYPE OF TRAVERSE
393
15
Advertisement
Table of Contents
