Table of Contents
Advertisement
5
Fixed Cycles: Pocket Milling / Stud Milling / Slot Milling
5.3
CIRCULAR POCKET (Cycle 252, DIN/ISO: G252)
Q338 Infeed for finishing? (incremental): Infeed in
the spindle axis per finishing cut Q338=0: Finishing
in one infeed. Input range 0 to 99999.9999
Q200 Set-up clearance? (incremental): Distance
between tool tip and workpiece surface Input range
0 to 99999.9999; alternatively PREDEF
Q203 Workpiece surface coordinate? (absolute):
Coordinate of the workpiece surface. Input range
-99999.9999 to 99999.9999
Q204 2nd set-up clearance? (incremental):
Coordinate in the spindle axis at which no collision
between tool and workpiece (fixtures) can occur.
Input range 0 to 99999.9999; alternatively PREDEF
Q370 Path overlap factor?: Q370 x tool radius
= stepover factor k. Input range: 0.1 to 1.9999;
alternatively PREDEF
Q366 Plunging strategy (0/1)?: Type of plunging
strategy:
Q385 Finishing feed rate?: Traversing speed of the
tool in mm/min during side and floor finishing. Input
range 0 to 99999.999, alternatively FAUTO, FU, FZ
Q439 Feed rate reference (0-3)?: Specify what the
programmed feed rate refers to:
0: Feed rate with respect to the tool center point
path
1: Feed rate with respect to the tool edge, but only
during side finishing, otherwise with respect to the
tool center point path
2: Feed rate refers to the tool cutting edge during
side finishing
to the tool path center
3: Feed rate always refers to the cutting edge
140
0 = vertical plunging. In the tool table, the
plunging angle ANGLE for the active tool must
be defined as 0 or 90. The TNC will otherwise
display an error message.
1 = helical plunging. In the tool table, the
plunging angle ANGLE for the active tool must
be defined as not equal to 0. The TNC will
otherwise display an error message.
Alternative: PREDEF
and
floor finishing; otherwise it refers
NC blocks
8 CYCL DEF 252 CIRCULAR POCKET
9 L X+50 Y+50 R0 FMAX M3 M99
HEIDENHAIN | TNC 320 | User's manual for cycle programming | 9/2016
Q215=0
;MACHINING
OPERATION
Q223=60
;CIRCLE DIAMETER
Q368=0.2
;ALLOWANCE FOR SIDE
Q207=500
;FEED RATE FOR
MILLNG
Q351=+1
;CLIMB OR UP-CUT
Q201=-20
;DEPTH
Q202=5
;PLUNGING DEPTH
Q369=0.1
;ALLOWANCE FOR
FLOOR
Q206=150
;FEED RATE FOR
PLNGNG
Q338=5
;INFEED FOR FINISHING
Q200=2
;SET-UP CLEARANCE
Q203=+0
;SURFACE COORDINATE
Q204=50
;2ND SET-UP
CLEARANCE
Q370=1
;TOOL PATH OVERLAP
Q366=1
;PLUNGE
Q385=500
;FINISHING FEED RATE
Q439=3
;FEED RATE REFERENCE
Advertisement
Table of Contents
