HEIDENHAIN TNC 320 User's Manual For Cycle Programming page 31

12 Using Touch Probe Cycles........................................................................................................... 293
12.1 General information about touch probe cycles............................................................................... 294
Method of function............................................................................................................................... 294
Consideration of a basic rotation in the Manual Operation mode........................................................ 294
Touch probe cycles in the Manual Operation and Electronic Handwheel operating modes................. 294
Touch probe cycles for automatic operation......................................................................................... 295
12.2 Before You Start Working with Touch Probe Cycles....................................................................... 297
Maximum traverse to touch point: DIST in touch probe table..............................................................297
Set-up clearance to touch point: SET_UP in touch probe table............................................................ 297
Orient the infrared touch probe to the programmed probe direction: TRACK in touch probe table...... 297
Touch trigger probe, probing feed rate: F in touch probe table............................................................ 298
Touch trigger probe, rapid traverse for positioning: FMAX................................................................... 298
Touch trigger probe, rapid traverse for positioning: F_PREPOS in touch probe table........................... 298
Executing touch probe cycles............................................................................................................... 299
12.3 Touch probe table............................................................................................................................... 300
General information...............................................................................................................................300
Editing touch probe tables.................................................................................................................... 300
touch probe data................................................................................................................................... 301
HEIDENHAIN | TNC 320 | User's manual for cycle programming | 9/2016
31