Table of Contents
Advertisement
14
Touch Probe Cycles: Automatic Datum Setting
14.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413)
Q384 Probe TS axis: Coord. 3rd axis? (absolute):
Coordinate of the probe point in the touch probe
axis, at which point the datum is to be set in the
touch probe axis. Only effective if Q381 = 1. Input
range -99999.9999 to 99999.9999
Q333 New datum in TS axis? (absolute): Coordinate
in the touch probe axis at which the TNC should
set the datum. Default setting = 0. Input range
-99999.9999 to 99999.9999
Q423 No. probe points in plane (4/3)?: Specify
whether the TNC should measure the stud with 4 or
3 probing points:
4: Use 4 measuring points (default setting)
3: Use 3 measuring points
Q365 Type of traverse? Line=0/arc=1: Definition
of the path function with which the tool is to move
between the measuring points if "traverse to
clearance height" (Q301=1) is active:
0: Move in a straight line between machining
operations
1: Move in a circular arc on the pitch circle diameter
between machining operations
350
HEIDENHAIN | TNC 320 | User's manual for cycle programming | 9/2016
Advertisement
Table of Contents
