G 5xxx
Figure 020-13: Combination Dispenser Removal
4.2
Cable Holder Removal
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove the door outer panel. See Section 030-4.3.
4. Slide the cable holder to the right off of its guide on the door inner panel.
5. Open the cable holder cover's 8 retaining clips with a small flathead
screwdriver.
6. Disconnect the ground wire from the door inner panel.
7. Release all wiring from the cable holder.
8. Remove the cable holder.
4.3
Locking Plate Adjustment/Replacement
Note: Ensure that the appliance is installed perfectly level.
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Open the door.
4. Loosen the flat round screw (T20) if adjusting, or remove the screw if
replacing.
5. Replace the locking plate or adjust it as necessary.
6. Retighten the flat round screw.
51
Technical Information