Water Diverter Removal - Miele G 4205 Technical Information

Technical Information
8. Close the opening with the service cap (mat. no. 06224660).
9. Unscrew the locknut.
10. Close the door.
Warning!
The appliance must not be tilted onto its right side, as this would cause water to run
into the fan.
11. Tip the appliance onto its back.
12. Remove the drip pan (Section 010-4.2).
13. Place towels or rags underneath the connection between the salt
container and water diverter.
14. Disconnect the wiring harness from the salt container reed switch.
15. Remove the salt container reed switch from the salt container.
16. Pull the salt container down and off of the water diverter.
Note:
Reassemble by following these instructions in reverse order.
The following should also be noted:
1. The two connections between the water diverter and the salt container have each
been fitted with 2 seals (O-rings). These should also be installed if this part is
being replaced. 4 O-rings are supplied with the spare part.
2. Re-install the wiring harness in its guides on the salt container.
3. Check all electrical components in the drip pan area for residual moisture.
4. Thoroughly remove any traces of brine that may have leaked in the toekick area.
5. After reassembly, fill the salt container with salt and water.
6. A short program (such as Short or Express) without load should be carried out.
This is to remove any salt residues that might be present in the cabinet and to
prevent possible corrosion.
7. Retighten all locknuts.
Warning!
Installation aids that contain silicone, e.g., silicone grease, are not suitable
for use in dishwashers because of the damage they can cause.
If, e.g., hoses or seals are treated with silicone in order to facilitate
installation, this could jam the circulation pump. Furthermore, ingredients in
silicone grease can evaporate and damage electrical components such as
heater relays.
4.12

Water Diverter Removal

1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Open the door.
4. Remove the bottom basket.
5. Unscrew the water diverter vent connection inside the cabinet.
6. Unscrew the salt container cap.
7. Remove the seal.
98
G 5xxx