Removing The Ntc Temperature Sensor; Non-Return Valve Removal; Removing The Sump - Miele G 4205 Technical Information

Technical Information
6. Remove as much residual water as possible from the sump and drain hose.
7. Close the door.
8. Tip the dishwasher onto its back.
9. Remove the drip pan. See Section 010-4.2.
10. Disconnect the wiring harness from the float switch.
11. Pull the float switch down and off of the sump.
4.20

Removing the NTC Temperature Sensor

1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Open the door.
4. Remove the bottom basket.
5. Remove the bottom spray arm.
6. Remove the filter combination.
7. Remove as much residual water as possible from the sump and drain hose.
8. Close the door.
9. Tip the dishwasher onto its back.
10. Remove the drip pan. See Section 010-4.2.
11. Disconnect the wiring harness from the NTC temperature sensor.
12. Remove the NTC temperature sensor from the sump.
13. Remove the seal from the temperature sensor.
4.21

Non-Return Valve Removal

1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Open the door.
4. Remove the bottom basket.
5. Remove the bottom spray arm.
6. Unscrew the bottom spray arm flange.
7. Remove the filter combination.
8. Push the locking tab inward (toward the sump) with a flathead screwdriver
and remove the valve from the sump.
4.22

Removing the Sump

1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove as much residual water as possible from the sump and drain hose.
4. Open the door.
5. Remove the bottom basket.
6. Remove the bottom spray arm.
7. Unscrew the bottom spray arm flange.
8. Remove the filter combination.
9. Close the door.
10. Tip the dishwasher onto its back.
11. Remove the drip pan. See Section 010-4.2.
12. Remove the float (Section 050-4.18) and float switch (Section 050-4.19).
104
G 5xxx