Replacing The Spray Arm Sensor - Miele G 4205 Technical Information

G 5xxx
Note:
To release the feed pipe in the rear panel feed-through area, hold the stub
at the rear and pull it while at the same time pushing in the seal from the
inside with a suitable screwdriver to reduce its cross-sectional area.
7. Close the door.
8. Tip the appliance onto its back.
9. Remove the drip pan. See Section 010-4.2.
10. Remove the right-side multi-plinth. See Section 040-4.3.
11. Disconnect the hose clip connection to the circulation pump.
4.6

Replacing the Spray Arm Sensor

1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove the right side panel (see Section 010-4.1).
4. Remove the appropriate spray arm sensor from the water diverter. See
Figure 050-18, Item 1.
5. Disconnect its plug connections.
95
Technical Information