Table of Contents
Advertisement
Installation
Damage caused by condensation.
In order to reduce the risk of damage
from condensation, the furniture in the
area around the dishwasher should be
designed for commercial use.
Only use furniture that is designed for
commercial use.
The dishwasher must be stable and
horizontal. Any unevenness in the floor level
and height of the machine can be
compensated for by adjusting the four feet.
The machine height can be adjusted from
820–880 mm using the machine feet.
Dishwashers with lids have an additional
15 mm in height.
The front machine feet can be adjusted with
an open spanner (spanner size 13); the rear
ones can be adjusted with a T20 Torx
screw.
If the runners of the rear machine feet are
not fitted, the machine feet can also be
adjusted with the open spanner.
They are adjusted upwards when turned
clockwise and downwards when turned
anti-clockwise.
If the dishwasher is to be installed next to
other machines and furniture or in a recess,
an installation space measuring at least
600 mm in width and 600 mm in depth is
required.
Dishwashers with active drying require a
space measuring 580 mm in depth.
Built-under installation
Risk of the machine tipping.
To ensure stability, a built-under
dishwasher must only be installed
beneath a continuous worktop that is
bolted to the adjacent cabinetry.
Install the dishwasher underneath a
bolted continuous worktop.
If the dishwasher is to be installed beneath
a continuous worktop, an installation space
measuring at least 600 mm wide, 600 mm
deep and 820 mm high is required.
Dishwashers with active drying require an
installation space measuring 580 mm in
depth.
Dishwashers with a plinth return are
supplied with a plinth filler panel. This can
be fitted instead of a skirting board.
When adjusting the dishwasher height,
the feet must not be unscrewed by more
than 60 mm.
Hose holder
The supplied hose holders can be used to
lay the power cable and the hoses for
supply and waste water in a way that saves
space.
The hose holder prevents hoses from
kinking or crushing when installing the
machine in tight recesses.
The power cable and hoses can be laid
either on the left or the right, depending on
the connection situation.
Installation
101
Advertisement
Table of Contents
