Installation; Built-Under Installation; Hose Holder - Miele PFD 400 Operating Instructions Manual

Installation

Installation
 Damage caused by condensation.
In order to reduce the risk of damage
from condensation, the furniture in the
area around the dishwasher should be
designed for commercial use.
Only use furniture that is designed for
commercial use.
The dishwasher must be stable and hori-
zontal. Any unevenness in the floor level and
height of the machine can be compensated
for by adjusting the four feet.
The machine height can be adjusted from
820–880 mm using the machine feet. Dish-
washers with lids have an additional 15 mm
in height.
The front machine feet can be adjusted with
an open spanner (spanner size 13); the rear
ones can be adjusted with a T20 Torx
screw.
If the runners of the rear machine feet are
not fitted, the machine feet can also be ad-
justed with the open spanner.
They are adjusted upwards when turned
clockwise and downwards when turned
anti-clockwise.
If the dishwasher is to be installed next to
other machines and furniture or in a recess,
an installation space measuring at least
600 mm in width and 580 mm in depth is re-
quired.
92

Built-under installation

 Risk of the machine tipping.
To ensure stability, a built-under dish-
washer must only be installed beneath a
continuous worktop that is bolted to the
adjacent cabinetry.
Install the dishwasher underneath a
bolted continuous worktop.
If the dishwasher is to be installed beneath
a continuous worktop, an installation space
measuring at least 600 mm wide, 580 mm
deep and 820 mm high is required.
Dishwashers with a plinth return are sup-
plied with a plinth filler panel. This can be
fitted instead of a skirting board.
When adjusting the dishwasher height,
the feet must not be unscrewed by more
than 60 mm.

Hose holder

The supplied hose holders can be used to
lay the power cable and the hoses for sup-
ply and waste water in a way that saves
space.
The hose holder prevents hoses from kink-
ing or crushing when installing the machine
in tight recesses.
The power cable and hoses can be laid
either on the left or the right, depending on
the connection situation.