Cancel With Fault Code - Miele PG 8504 Operating Instructions Manual

Cancel with fault code

If a programme is cancelled and a fault code appears, e.g.
represents a number), there could be a serious technical fault.
In the event of a programme being cancelled and a fault code being shown:
Switch the machine off using the  button.

Wait approximately 10 seconds before switching the machine on again with the 

button.
Start the previously selected programme again.

If the same message appears again:
Make a note of the fault message.

Switch the machine off using the  button.

Contact Miele Service.

Please also read the notes regarding the following fault codes.
Problem
Fault 403-405
Fault 406–408
Fault 412–414
Fault 440
Cause and remedy
A programme has been cancelled because water intake by
the machine was insufficient or severely restricted.
Open the stopcocks fully.

Follow the additional information given in the

water inlet message.
A programme was cancelled because the water flow rate is
insufficient.
Check whether the stopcocks are fully opened.

Please refer to the information regarding minimum flow

pressure in "Connection to the water supply" and
"Technical data".
Check the filters in the water supply.

In this instance, please contact the Miele Customer

Service Department for advice.
A programme was cancelled because the water flow rate is
too high.
Refer to the information regarding recommended

maximum flow pressure and maximum permissible static
water pressure in "Connection to the water supply" and
"Technical data".
In this instance, please contact the Miele Customer

Service Department for advice.
The float switch in the base of the machine has not been
activated. The switch might be blocked.
Remove the filter combination.

Check the float switch to make sure it moves freely. The

float switch is located in the base of the machine behind
the spray arm.
Problem solving guide
Fault XXX
(where XXX
Check
103