Hardware Description And Installation; Led Indicators - D-Link DSL-2740E User Manual

Section 3 – Web Configuration

LED Indicators

Note:
The figures in this document are for reference only.
The following table describes the LEDs of the device.
LED Color
Green
Red
Power
Green
LAN
Green
2.4GHz
Green
WPS
Green
DSL
D-Link DSL-2740E User Manual

Hardware Description and Installation

Status
On The initialization of the system is complete.
On The device is powered on.
Blinking The firmware is upgrading.
Off The Ethernet interface is not properly connected.
Blinking The Ethernet interface is properly connected and data is being transmitted.
On The Ethernet interface is properly connected, but no data is being transmitted.
Blinking The WLAN function is enabled and data is being transmitted on the WLAN.
On The WLAN function is enabled, but no data is being transmitted on the WLAN.
Off The WLAN function is disabled.
Blinking WPS is successfully triggered.
Solid on for 5
seconds and Connection is successfully established between the router and the client through WPS.
then turns off
Off No signal is being detected.
Blinking The device is handshaking with the physical layer of the office end.
On A connection is set up with the physical layer of the office end.
Figure 1 Front panel
Description
9