D-Link DSL-2740E User Manual page 32

Section 4 – Troubleshooting
WPS
There are 3 methods to realize wireless connection through WPS.
- PBC
Click the Start PBC button in this page. And then click WPS button on the client
to be connected within 2 minutes. The connection will be established.
- Based on the PIN of wireless client to be connected.
In Input Client PIN textbox, input the PIN code of the wireless client to be
connected. And then click on Start PIN
- Based on the PIN of DSL-2740E.
1) Select Enabled to enable WPS.
4) Input the Self-PIN number at wireless client to be connected.
Access Control List
You can specify what services are accessible form LAN or WAN parts.
in this ACL table are used to permit certain types of data packets from your local
network or Internet network to the Gateway.
be helpful in securing or restricting the Gateway management.
Select direction, LAN ACL Switch and click Apply to save the settings.
In ACL settings, please enter the IP address range and check which service to
configure. Then click Add to create a new rule.
D-Link DSL-2740E User Manual
Entries
Using of such access control can
28