D-Link DSL-2740E User Manual page 27

Section 4 – Troubleshooting
1) Adding a PVC in MAC Encapsulation Routing (MER) or IP Over ATM
(IPoA) mode
If the protocol is selected to MAC Encapsulation Routing (MER), the page
shown as the right figure appears.
2) In Protocol drop-down list, select 1483 MER
3) In Encapsulation Mode drop-down list, select an option according to the
information provided by your ISP.
4) Select IPv4 or IPv6 according to the information provided by ISP.
5) In WAN IP Setting section, choose an option according to the information
provided by your ISP.

DHCP: the dynamic WAN IP address will be assigned by your ISP.

Use the following address: A static WAN IP address is provided to
you by your ISP. Input the static WAN IP address and other information provided
by your ISP.
6) For other entries which are not mentioned above, you can keep them as
defaults.

Adding a PVC in Bridging mode
1) In Protocol drop-down list, select 1483 Bridge
2) In Encapsulation Mode drop-down list, select an option according to the
information provided by your ISP.
For PVC in Bridging mode, keep the settings as defaults.
Note:
If the connection protocol is in Bridging mode, the connected PC must
dial for WAN connection with installed dial-up software.
Step 3 After setting (take adding a PPPoE PVC as an example), click Add
and the page skip to the page shown as the right figure appears. You
can edit or delete the PVCs in the table.
D-Link DSL-2740E User Manual 23