D-Link DSL-2740E User Manual page 26

Section 4 – Troubleshooting

Adding a PVC in PPPoE or PPPoA mode
If the protocol is selected to PPP over Ethernet (PPPoE) or PPP over ATM
(PPPoA), the page shown as the right figure appears.
1) In Protocol drop-down list, select PPPoE (or PPPoA).
2) In Encapsulation Mode, select an option according to the information
provided by your ISP.
3) Select IPv4 or IPv6 according to the information provided by ISP.
4) In the PPP Username and PPP Password textbox, input the Username
and password of PPPoE account provided by your ISP.
5) In the Dial-up Mode drop-down list, select an option as you demand.
There are 3 modes available: Continuous, Connect On Demand, Manual.
- Continuous: The system automatically keeps dialing for WAN
connection once the connection is off-line.
- Connect On Demand: The system automatically dials for WAN
connection once network access request is detected. If no request is
sent from the LAN within the IdleTime, the system automatically
disconnect from the internet. You can set the Idle Time as you need.
- Manual: Manually dial to connect the WAN once powering on the
Router.
6) For other entries which are not mentioned above, you can keep them as
defaults.
D-Link DSL-2740E User Manual 22