D-Link DSL-2740E User Manual page 14

Section 3 – Web Configuration
LED Color
Green
Internet
Red
The following table describes the interfaces of the device.
Interface/Button
DSL
LAN4/3/2/1
WPS
WIRELESS ON/OFF
ON/OFF
12V DC IN (power)
Reset (On the bottom side)
D-Link DSL-2740E User Manual
Status
Off The device is under the Bridge mode or powered off.
On A connection is set up and no traffic is detected.
Blinking Data is being transmitted over Internet.
On The device is attempted to become IP connected, but failed.
RJ-11 interface for connecting the host to the telephone jack on the wall or the MODEM interface of the
splitter through a telephone line.
For a PC or other Ethernet-abled device to join the LAN of 2750U by being connected to this interface with
RJ-45 cable.
Press and hold the button for 5 seconds starts WPS negotiation.
Press and hold the button for 5 seconds starts WLAN.
Power switch, which is used to power on or power off the router.
Interface for connecting the power adapter.
Press and hold the button for 1 second to restore the factory defaults.
Description
Figure 2 Rear panel
Description
10