Time And Date - D-Link DSL-2740E User Manual

Section 4 – Troubleshooting
The default security mode is None. If the security mode is set to None, your
wireless network can be connected by all wireless clients that can detect the
SSID of this network.
If the Security Mode is set to WPA(TKIP), WPA(AES), WPA2(TKIP), WPA(AES),
or WPA2 Mixed,, the page is shown as the right figure appears. Take WPA2
Mixed as an example.
Step 1 In Security Mode drop-down list, select WPA2 Mixed.
Step 2 In WPA Authentication Mode, select Personal (Pre-Share-Key)
Step 3 In Pre-Shared Key Format drop-down list, select Passhrase.
Step 4 Configure the WPA Authentication Mode.
- Personal (Pre-Share-Key): WPA-PSK does not require an
authentication server. You need to set a Pre-shared Key (wireless
network password) for your wireless network.
- Enterprise (RADIUS): When WPA enterprise is enabled, the router
uses EAP (802.1x) to authenticate clients via a remote RADIUS
server. Enter the port, IP address, and password of the Radius
server. The wireless clients are required to enter the username
and password provided by the Radius server.
Step 5 Enter the Pre-Share Key, at least for 8 charcacters..
Step 6 After setting, click Apply Changes to save the settings.

Time and Date

Choose SETUP > Time and Date. The page shown in the right figure appears.
This page allows you to configure IPv6 LAN.
In the Time and Date page, you can configure, update, and maintain the correct
time on the internal system clock. You can set the time zone that you are in and
the network time protocol (NTP) server. You can also configure daylight saving to
automatically adjust the time when needed.
Select Set NTP Server Manually and select the NTP server of D-Link. You can
also specify the NTP server by selecting Other.
Select Daylight if necessary. Set the daylight as you want.
Click Apply Changes to save the settings.
D-Link DSL-2740E User Manual 26