Setting The Alarm Function; Setting The Post-Meal Alarm (Pp2 Alarm); Setting The Time Alarm (Alarm 1 ~ 3) - i-SENS CareSens N Manual

Setting the Alarm Function

Four types of alarms can be set in the CareSens N Meter: one
post-meal alarm (PP2 alarm) and three time set alarms (alarm1-3).
The PP2 alarm goes off 2 hours after setting the alarm.
The alarms ring for 15 seconds and can be silenced by pressing
, or the S button or by inserting a test strip.

Setting the post-meal alarm (PP2 alarm)

Step 1 Setting the PP2 alarm On
Without inserting a test strip,
press and hold for 3 seconds to
set the post-meal alarm. The 'PP2'
character, the bell ( ) symbol
and then the 'On' character will
be displayed. The screen will
then automatically change to
the memory check mode. At this
time, the bell ( ) symbol, indicating that the PP2 alarm has
been set, will be displayed on the screen.
Step 2 Setting the PP2 alarm OFF
To turn off the PP2 alarm, press
and hold for 3 seconds. The
'PP2' character, the bell (
) symbol and then the 'OFF'
character will appear on the
screen. Then the screen will
change automatically to the
memory check mode without the
bell ( ) symbol being displayed.
38 www.i-sens.com
Setting the Time Alarms (alarm 1-3)
Step 1
Without inserting a test strip, press and
the S button simultaneously for 3 seconds
to enter the time alarm mode. The 'alarm1'
will be displayed while the 'OFF' character
blinks on the screen.
Step 2
On pressing , the 'alarm1' is set and the 'On'
character is displayed on the screen. Press
again to cancel the 'alarm1' . The 'OFF' symbol
will blink on the screen .
Step 3
Press to adjust the time of the 'alarm1' .
A number representing the time will blink
on the screen. Press to set the time.
Press to end.
symbol vanishes
www.caresens.co.nz 39