Setting The Alarm Function - i-SENS GM505PAD User Manual

Setting the Alarm Function

Four types of alarms can be set in the CareSens N Meter: one
post-meal alarm (PP2 alarm) and three time set alarms (alarm1-3).
The PP2 alarm goes off 2 hours after setting the alarm.
The alarms ring for 15 seconds and can be silenced by pressing
, or the S button or by inserting a test strip.
Setting the Post-meal Alarm (PP2 alarm)
Step 1 Setting the PP2 Alarm On
Without inserting a test strip,
press and hold for 3 seconds
to set the post-meal alarm. 'PP2' ,
the bell ( ) symbol and 'On'
will be displayed. The screen
will then automatically change
to the memory check mode. At
this time, the bell ( ) symbol,
indicating that the PP2 alarm has been set, will be displayed on
the screen.
Step 2 Setting the PP2 Alarm OFF
To turn off the PP2 alarm, press
and hold for 3 seconds. 'PP2' ,
the bell ( ) symbol, and 'OFF' will
appear on the screen. Then the
screen will change automatically
to the memory check mode
without the bell ( ) symbol
displayed.
38 www.i-sens.com
Setting the Time Alarms (alarm 1-3)
Step 1
Without inserting a test strip, press and
the S button simultaneously for 3 seconds
to enter the time alarm mode. 'alarm1'
will be displayed while 'OFF' blinks on the
screen.
Step 2
On pressing , 'alarm1' is set and 'On' is
displayed on the screen. Press again to
cancel 'alarm 1' and 'OFF' will blink on the
screen.
Step 3
Press to adjust the time of 'alarm1' .
A number representing the time will blink
on the screen. Press to set the time.
Press to end.
symbol disappears
www.i-sens.com 39