Putting In Or Replacing The Batteries; Caring For Your System - i-SENS CareSens N Manual

Putting in or Replacing the Batteries
The CareSens N Meter comes with two 3.0 V lithium batteries.
Before using the meter, check the battery compartment and
insert batteries if empty.
When using your meter and seeing the
display for the first time, the batteries should be replaced as soon
as possible. The test results might not be saved if the batteries run
out.
Step 1
Make sure the meter is turned off. Push the
cover in the direction of the arrow to open
the battery compartment.
Step 2
Remove the old batteries one by one by
lifting with the index finger and pulling it
out with your thumb and index fingers as
shown in the figure on the right. Insert two
new batteries with the + side facing up and
make sure the batteries are inserted firmly.
Step 3
Place the cover on the battery
compartment. Push down until you hear the
tab click into place.
Note: Removing the meter batteries will not affect your
stored result. However, you may need to reset your meter
settings. See pages 14-16 .
8 www.i-sens.com
symbol appear on the

Caring for Your System

Use a soft cloth or tissue to wipe the meter exterior. If necessary,
the soft cloth or tissue might be dipped in a small amount of
alcohol.
Do not use organic solvents such as benzene, or acetone, or
household and industrial cleaners that may cause irreparable
damage to the meter.
Caution:
• D o not expose the meter to direct sunlight or heat for an
extended period of time.
• D o not let dirt, dust, blood, or water enter into the meter's
test strip port.
• D o not drop the meter or submit it to strong shocks.
• D o not try to fix or alter the meter in any way.
• K eep the meter away from strong electromagnetic fields
such as cell phones and microwave ovens.
• C areSens N meter should be used only with CareSens N
strips.
• K eep the meter in a cool and well ventilated place.
• S tore all the meter components in the portable case to
prevent loss.
www.caresens.co.nz 9