Linking And Unlinking The Remote Keyless Entry Transmitter To Memory - Jeep Grand Cherokee 2016 Owner's Manual

164 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE:
• Memory profiles can be set without the vehicle in
PARK, but the vehicle must be in PARK to recall a
memory profile.
• To set a memory profile to your RKE transmitter, refer
to "Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory" in this section.
Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory
Your RKE transmitters can be programmed to recall one
of two pre-programmed memory profiles by pushing the
UNLOCK button on the RKE transmitter.
NOTE: Before programming your RKE transmitters you
must select the "Memory To FOB" feature through the
Uconnect system screen. Refer to "Uconnect Settings " in
"Understanding Your Instrument Panel" for further in-
formation.
To program your RKE transmitters, perform the follow-
ing:
1. Cycle the vehicles ignition to the OFF position.
2. Select a desired memory profile (1) or (2).
NOTE: If a memory profile has not already been set,
refer to Programming The Memory Feature in this
section for instructions on how to set a memory profile.
3. Once the profile has been recalled, push and release
the SET (S) button on the memory switch.
4. Within five seconds, push and release button (1) or (2)
accordingly. "Memory Profile Set" (1 or 2) will display
in the instrument cluster.
5. Push and release the LOCK button on the RKE trans-
mitter within 10 seconds.