Enabling And Disabling Parksense; Service The Parksense Park Assist System - Jeep Grand Cherokee 2016 Owner's Manual

244 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
ParkSense will retain its last known configuration state
through ignition cycles.

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with the
ParkSense switch.
When the ParkSense switch is pushed to dis-
able the system, the instrument cluster will
display the "PARKSENSE OFF" message for
approximately five seconds. Refer to "Driver
Information Display (DID)" in "Understanding Your
Instrument Panel" for further information. When the
shift lever/gear selector is moved to REVERSE and the
system is disabled, the
"PARKSENSE OFF" message for as long as the vehicle is
in REVERSE.
The ParkSense switch LED will be ON when ParkSense is
disabled or requires service. The ParkSense switch LED
will be OFF when the system is enabled. If the ParkSense
DID will display the
switch is pushed, and the system requires service, the
ParkSense switch LED will blink momentarily, and then
the LED will be ON.

Service The ParkSense Park Assist System

During vehicle start up, when the ParkSense System has
detected a faulted condition, the instrument cluster will
actuate a single chime, once per ignition cycle, and it will
display the PARKSENSE UNAVAILABLE WIPE REAR
SENSORS , PARKSENSE
FRONT SENSORS , or the PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED message for five seconds.
When the shift lever/gear selector is moved to Reverse
and the system has detected a faulted condition, the
Driver Information Display (DID) will display a
PARKSENSE UNAVAILABLE WIPE REAR SENSORS ,
PARKSENSE UNAVAILABLE WIPE FRONT SENSORS
or PARKSENSE UNAVAILABLE SERVICE REQUIRED
pop up message for five seconds. After five seconds, a car
UNAVAILABLE WIPE