Linking And Unlinking The Remote Keyless Entry Transmitter To Memory - Jeep grand cherokee Owner's Manual

2. Adjust all memory profile settings to desired prefer-
ences (i.e., seat, side mirror, power tilt and telescopic
steering column [if equipped], and radio station pre-
sets).
3. Push and release the S (Set) button on the memory
switch.
4. Within five seconds, push and release either of the
memory buttons (1) or (2). The Driver Information
Display (DID) will display which memory position
has been set.
NOTE:
• Memory profiles can be set without the vehicle in
PARK, but the vehicle must be in PARK to recall a
memory profile.
• To set a memory profile to your RKE transmitter, refer
to "Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory" in this section.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157
Linking And Unlinking The Remote Keyless Entry
Transmitter To Memory
Your RKE transmitters can be programmed to recall one
of two pre-programmed memory profiles by pushng the
UNLOCK button on the RKE transmitter.
NOTE: Before programming your RKE transmitters you
must select the "Memory To FOB" feature through the
Uconnect® system screen. Refer to "Uconnect® Settings "
in "Understanding Your Instrument Panel" for further
information.
To program your RKE transmitters, perform the follow-
ing:
1. Cycle the vehicles ignition to the OFF position.
2. Select a desired memory profile (1) or (2).
NOTE: If a memory profile has not already been set,
refer to Programming The Memory Feature in this
section for instructions on how to set a memory profile.
3