To Arm The System; To Disarm The System - Jeep Grand Cherokee 2016 Owner's Manual

To Arm The System

Follow these steps to arm the Vehicle Security Alarm:
1. Make sure the vehicles ignition is cycled to the "OFF"
position (refer to Starting Procedures in Starting
And Operating for further information).
• For vehicles equipped with Keyless Enter-N-Go,
make sure the vehicle ignition system is OFF.
• For vehicles not equipped with Keyless Enter-N-Go,
make sure the vehicle ignition system is OFF, and the
key is physically removed from the ignition.
2. Perform one of the following methods to lock the
vehicle:
• Push LOCK on the interior power door lock switch
with the driver and/or passenger door open.
• Push the LOCK button on the exterior Passive Entry
Door Handle with a valid Key Fob available in the
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 21
same exterior zone (refer to Keyless Enter-N-Go in
Things To Know Before Starting Your Vehicle for
further information).
• Push the LOCK button on the Remote Keyless Entry
(RKE) transmitter.
3. If any doors are open, close them.

To Disarm The System

The Vehicle Security Alarm can be disarmed using any of
the following methods:
• Push the UNLOCK button on the Remote Keyless
Entry (RKE) transmitter.
• Grasp the Passive Entry Unlock Door Handle (if
equipped, refer to Keyless Enter-N-Go in Things To
Know Before Starting Your Vehicle for further infor-
mation).
2