Parksense Sensors; Parksense Warning Display; Parksense Display - Jeep Grand Cherokee 2016 Owner's Manual

Hide thumbs Also See for Grand Cherokee 2016:

Table of Contents

ParkSense can be active only when the shift lever/gear

selector is in REVERSE. If ParkSense is enabled at this

shift lever/gear selector position, the system will remain

active until the vehicle speed is increased to approxi-

mately 7 mph (11 km/h) or above. When in REVERSE

and above the system's operating speed, a warning will

appear within the Driver Information Display (DID)

indicating the vehicle speed is too fast. The system will

become active again if the vehicle speed is decreased to

speeds less than approximately 6 mph (9 km/h).

ParkSense Sensors

The four ParkSense sensors, located in the rear fascia/

bumper, monitor the area behind the vehicle that is

within the sensors' field of view. The sensors can detect

obstacles from approximately 12 in (30 cm) up to 79 in

(200 cm) from the rear fascia/bumper in the horizontal

direction, depending on the location, type and orienta-

tion of the obstacle.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 225

The ParkSense Warning screen will only be displayed if

Sound and Display is selected from the Customer -

Programmable Features section of the Uconnect System.

Refer to Uconnect Settings" in "Understanding Your

Instrument Panel" for further information.

The ParkSense Warning screen is located within the DID.

It provides visual warnings to indicate the distance

between the rear fascia/bumper and the detected ob-

stacle. Refer to "Driver Information Display (DID)" for

further information.

When the vehicle is in REVERSE and an obstacle has

been detected, the warning display will turn ON indicat-

ing the system status.

Table of Contents