Jeep Grand Cherokee 2016 Owner's Manual page 257

Training The Garage Door Opener
1 — Door Opener
2 — Training Button
1. Place the ignition in the ON/RUN position.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 255
2. Place the hand-held transmitter 1 to 3 inches (3 to 8
cm) away from the HomeLink button you wish to
program while keeping the HomeLink indicator light
in view.
3. Push and hold the HomeLink button you want to
program while you push and hold the hand-held
transmitter button.
4. Continue to hold both buttons and observe the indi-
cator light. The HomeLink indicator will flash slowly
and then rapidly after HomeLink has received the
frequency signal from the hand-held transmitter. Re-
lease both buttons after the indicator light changes
from slow to rapid.
5. At the garage door opener motor (in the garage),
locate the "LEARN" or "TRAINING" button. This can
usually be found where the hanging antenna wire is
attached to the garage door opener/device motor.
3