Motorola HH1620 User Manual page 25

1.
If you are currently running broadband to a single computer, unplug the Ethernet cable
that runs between your modem and PC from the back of your PC and plug it into the
port labeled WAN on the back of your router.
If you are not running broadband to a single computer, connect an Ethernet cable to the
WAN port on your router.
2.
Connect the other end of the same cable to your cable or DSL modem. You have now
connected the router to the modem. It will be necessary to restart your cable or DSL
modem after making this connection.
3.
Your PC's wireless adapter may need to be configured to work with the HH1620.
By default, the HH1620 has a LAN IP Address of 192.168.1.1, and dynamically assigns
an IP Address to connected devices. The PC will not communicate properly with the
HH1620 if the wireless adapter is not configured either:
(a) to accept a dynamic IP Address, or
(b) with a compatible static IP Address (i.e., 192.168.10.x, where x is a number between
2 and 254).
To make any necessary adjustments to your PC's wireless adapter, you can follow the
instructions in this section under Configuring Computers to Communicate with the
HH1620.
4.
To connect the PC to the HH1620 through a wireless connection, use your PC's
wireless adapter utility to verify:
(a) the selection of the SSID (Service Set Identifier) of the HH1620, which by default is
set to motorolaABCDEF012345, where the final 12 characters represent the HH1620's
Wireless MAC address (see the image below to identify the HH1620's Wireless MAC
address from the product label),
fig
(b) that authentication is set to Open, since the HH1620 by default has no wireless
authentication enabled, and
(c) that no encryption is enabled, since the HH1620 by default has no wireless
encryption enabled.
Refer to your wireless adapter's documentation for instructions on how to review and
adjust these settings.
NOTE: You can make wireless connections between the HH1620 and other devices by
repeating Steps 3 and 4 with each of those devices, but it is recommended to wait until
after securing your wireless network to do so.
HH1620 Wireless VoIP Gateway
User's Guide
18
Troubleshooting