Table of Contents
Advertisement
SC-F9300 Series
User's Guide
Details of the Menu
The Media Setup Menu
The Media Setup menu can be accessed directly by pressing the M button.
* indicates default settings.
Item
Feed To Cut Position
Easy Media Setup
Screen Display
Media Remaining
Print Length
Media Remaining
Print Remaining Length
Length
Remaining Alert
Reset Print Length
Using the Control Panel Menu
Parameter
Explanation
Sends the end of the print to the cutting groove.
You can quickly and easily register media settings using the Wizard to
perform optimum printing according to the size and type of the media
being used.
"Saving New Media Settings" on page 45
U
Select the item to display media information for the status screen.
When Media Remaining is selected, the length of the remaining roll
media is displayed after the
When Print Length is selected, the length printed per job is displayed
after the
feed button or the after heater is not included.
If you set Length in Media Remaining to Off, the remaining media is
not displayed on the status screen.
If Auto Reset is set to Off in the next section's Reset Print Length, a
cumulative value for the print length is displayed until you do Manual
Reset.
Print
Use Print Remaining Length to print the amount of media remaining
on the current roll before replacing it with another type of media to be
loaded. You can then enter this number as the media the length the
next time the roll is used.
Off, 1.0 to 600.0
Enter a value for overall roll length between 1.0 and 600.0 m. You can
*
set in 0.5m increments. When you select Off, the following remaining
m (120
)
amount is not calculated.
❏
Display the media remaining on the status screen
❏
Display warning message for remaining amount of media
*
An alert will be displayed if the amount of media remaining reaches this
1 to 15 m (5
)
length. Choose from values between 1 and 15 m. You can set in 1 m
increments.
icon in increments of 0.1 m.
icon in increments of 1 m. The amount fed by the media
94
Advertisement
Table of Contents
