Attaching The Roll Core - Epson SC-F9300 series User Manual

Hide thumbs Also See for SC-F9300 series:
Table of Contents

Advertisement

SC-F9300 Series
User's Guide
Deformed

Attaching the Roll Core

Preparing
Get a take-up roll core that is the same width as the
media.
Get a commercially available adhesive tape.
Loading
A
After confirming that the media is loaded
correctly, keep the d button pressed until the
edge of the media reaches the roll core holder.
Basic Operations
c
Important:
Always press the d button to feed the media.
If the media is pulled by hand, the media
may twist during take-up.
B
Loosen the roll core holder fixing screws on
both sides and adjust the roll core holders so
that the distance between the two is wider than
the media.
If the roll supports are not positioned evenly,
move them so that they are even.
c
Important:
If the left-side roll core handle's shaft is not
visible, rotate the handle as shown in the
illustration until it stops. The roll core
cannot be properly loaded if the handle's
shaft is not visible.
34

Advertisement

Table of Contents
loading

Table of Contents