Table of Contents
Advertisement
SC-F9300 Series
User's Guide
However, when reservation is done, a warning is not
displayed when the estimated amount of ink becomes
low. Refill the ink with one pack of ink if the
remaining ink is 70 mm or less from the bottom of the
ink tank.
See steps 2 to 6 in "Procedure for Ink Refills" for the
procedure to replace chip units.
"Procedure for Ink Refills" on page 66
U
You can confirm whether or not a chip unit is
reserved by looking at the chip unit's status icon.
"Understanding the Display" on page 14
U
Precautions when refilling ink
Read the Safety Data Sheet before performing the
procedure.
You can download it at your local Epson Web site.
Caution:
Note the following points when refilling ink.
❏ Gently tear off the ink pack spout opening.
If you cut the nozzle too quickly, ink may
splatter.
❏ Do not squeeze open ink packs. Ink may
spill.
❏ Gently tilt the ink pack when pouring ink
into the ink tank.
Maintenance
c
Important:
❏ Epson recommends the use of genuine Epson
ink packs.
Epson cannot guarantee the quality or
reliability of nongenuine ink. The use of
non-genuine ink may cause damage that is
not covered by Epson's warranties, and under
certain circumstances, may cause erratic
printer behavior.
Information about non-genuine chip unit
status may not be displayed, and use of
non-genuine ink is recorded for possible use
in service support.
❏ Genuine Epson ink, other than those specified
here, could cause damage that is not covered
by Epson's warranties.
"Options and Consumable Products" on
U
page 117
❏ Do not place items on the ink tank or subject
the ink tank to strong impacts. The ink tank
could become detached.
Contact your dealer or Epson Support.
Procedure for Ink Refills
A
If the Check Ink Levels message is displayed on
the control panel screen, check the ink level in
the ink tank by using the scale on the ink pack.
66
Advertisement
Table of Contents
