Others - Epson SC-F9300 series User Manual

SC-F9300 Series User's Guide
F
Pull the media to the cutter groove and use a
cutter to remove torn or creased portions.
G
Manually rewind the cut media.
H
Remove any media that remains inside the
printer.
I
Turn the printer on.
c
Important:
If the printer is left off for an extended
period, the print head will be left uncapped
and dry out, and will not print properly
when printing resumes.
Turning the printer on automatically caps
the print head.
Reload the media and resume printing.
"Loading media" on page 27
U
Media slips off when printing starts
Are you cutting media partway with After
o
Heater Feed set to either Short, Rewind or
Long, Rewind?
If media is cut at the point just after printing and
then rewound when the next print job starts, the
media may come off the pressurization roller and
printing cannot be performed.
When cutting after printing, hold down the u
button to rewind the end of the print to the cutter
groove, and then cut.
Problem Solver

Others

Discrepancies in the ink refill period
and the charge state display
There may be discrepancies due to the
o
usage state and the usage environment.
You may be able to clear the discrepancies by
implementing Charge Setting on the Printer
Setup menu. See the following for more information.
"The Printer Setup Menu" on page 99
U
If it does not clear even when you implement the
Charge Setting, clear the discrepancies by
continuing to use the chip unit without doing a
reservation.
Heater automatically turns Off
The heater turns off if no print job is received for
o
some time and no errors in the printer occur. The
time before the heaters automatically switch to Off
can be selected using the Sleep Mode option in the
setup menu. U
page 99
The heaters will be reactivated when a print job is
received, the media loading lever is used, or another
operation involving printer hardware is performed.
The control panel display keeps
turning off.
Is the printer in sleep mode?
o
When no operations are performed on the printer
for the time set in Sleep Mode from the setup
menu, the printer enters sleep mode. The time
before entering sleep mode can be changed in the
Printer Setup menu.
"The Printer Setup Menu" on page 99
U
The heaters will be reactivated and sleep mode will
end when a print job is received, the media loading
lever is used, or another operation involving printer
hardware is performed.
Forgotten password for network
setup protection
Contact your dealer or Epson Support.
o
115
"The Printer Setup Menu" on