Epson SC-F9300 series User Manual page 30

SC-F9300 Series User's Guide
c
Important:
If the roll holder is inserted into the roll core
insufficiently, media is not fed correctly
during printing because of slippage between
the roll holder and roll core.
This may cause banding in the print results.
M
While pressing from the top of the roll holder,
tighten the fixing screw until it no longer turns.
Tighten it so the roll holder does not move.
c
Important:
If the roll holder screw is loose, the roll holder
may move during printing. This could cause
stripes and unevenness in the print results.
Basic Operations
N
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the
handle any further. Failure to observe this
precaution could damage the roll holder.
If part A is still visible even after the handle
has been turned fully, rewind the handle.
Loosen the roll holder screw on the right side,
and then restart from Step 4.
O
Insert the media approximately 30 cm into the
opening, then lower the media loading lever.
30