Epson SC-F9300 series User Manual page 114

SC-F9300 Series User's Guide
Printing does not stop when the roll
ends.
Is the item for having the printer detect the
o
end of the media set to Off?
When Media End Check is set to Off from the
Printer Setup menu, the end of the media is not
detected.
"The Printer Setup Menu" on page 99
U
Removing Jammed Media.
Follow the steps below to remove jammed media.
Caution:
Be careful not to trap your hands or fingers when
opening or closing the front cover. Failure to
observe this precaution could result in injury.
A
Turn off the printer.
If a message is displayed and the printer will
not turn off, unplug both power cables.
B
Open the front cover.
C
Move the media edge plates to the right and left
sides of the platen. Hold both tabs on the media
edge plates to move them.
c
Important:
Cease use of the printer if the media edge
plates are deformed. Continued use could
damage the pressure rollers or print head.
Contact your dealer or Epson Support.
Problem Solver
D
If the print head is over the media, move it
away from the jam.
c
Important:
Move the print head only after moving the
media edge plates out of the way. Contact
with deformed media edge plates could
damage the print head.
E
Raise the media loading lever.
114