Epson SC-F9300 series User Manual page 53

SC-F9300 Series User's Guide
The gray area in the illustration below shows the printable area. The arrow indicates the feed direction.
* When Media Size Check is set to Off, this is 1,626 mm (64 inches) regardless of the width of the loaded media.
A D
to indicates the margins on all four sides. See the following for more details.
Margin Explanation
Position
*1, *2
A This can be set in RIP. To maintain media feeding accuracy, if the settings are less than
Rear
5 mm or more than 17 mm, the settings are switched to 5 mm and 17 mm respectively.
B
Leading This can be set in RIP. Differs by the length the media was pulled when the media is
*1 loaded. For continuous printing, although the margins set in RIP are added, to
edge
maintain media feeding accuracy, if the setting is less than 5 mm the setting is
switched to 5 mm.
*3, *4
C The value selected for Side Margin(Left) in the printer's setup menu. The default setting
Left edge
is 5 mm.
D
Right The total of the values selected for Print Start Position and Side Margin(Right) in the
*3, *4 printer's setup menu. The default setting for Print Start Position is 0 mm and Side
edge
Margin(Right) is 5 mm.
*1 The set margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
Basic Operations
53
Available
Setting
Range
5 to 17 mm
5 mm or more
3 to 25 mm
3 to 825 mm