Analyzer Preparation; Unpacking The Analyzer - Thermo Scientific Orion 2120XP User Manual

Unpacking the
Analyzer

Unpacking the Analyzer

Thermo Scientific Orion 2120XP Calcium Hardness Analyzer User Guide
Chapter II
Thermo Scientific Orion analyzers are assembled, tested and packaged with
great care. Refer to Figure II-1.
Report any obvious damage of shipping container to carrier and hold for
inspection. The carrier (not Thermo Fisher Scientific) is responsible for any
damage incurred during shipment.
1. Open the outer box. Remove the top two foam corner support pieces.
2. Open the inner box. This box should contain the analyzer and ATC
temperature probe, calcium electrode box, reference electrode box,
calcium standard solutions kit (two 2 oz bottles of 191 ppm CaCO
standard and two 2 oz bottles of 1920 ppm CaCO
options kit and user guide CD.
3. Remove the cardboard retaining shell by sliding it over the entire
mounting board and the analyzer.
4. Carefully remove the entire mounting board with analyzer from the
inner box.
Note: Do not lift or pull the analyzer by the fluidics or the
electronic components.
5. Unbolt the analyzer from the mounting board by removing the four
mounting bolts with a 9/16 wrench. These bolts may be discarded.
6. Carefully place the analyzer at a convenient location until proper
installation can be completed.
Figure II-1

Analyzer Preparation

3
standard), the
3
II-1