Resetting The Escape Sequence; Resetting The Rmc To Factory Defaults - Compaq ES40CSLP Installation, User & Service Manual

4.7.7 Resetting the Escape Sequence

The RMC set escape command sets a new escape sequence. The new escape sequence can be
any character string, not to exceed 14 characters. A typical sequence consists of two or more
control characters. It is recommended that control characters be used in preference to ASCII
characters. Use the status command to verify the new escape sequence before exiting the
RMC.
The following example consists of two instances of the Esc key and the letters "FUN." The "F"
is not displayed when you set the sequence because it is preceded by the escape character.
Enter the status command to see the new escape sequence.
RMC> set escape
Escape Sequence: un
RMC> status
.
.
.
Escape Sequence: ^[^[FUN
____________________________ Caution __________________________
Be sure to record the new escape sequence. Restoring the default sequence requires
moving a jumper on the system motherboard.
______________________________________________________________
4.8 Resetting the RMC to Factory Default s
If the RMC escape sequence is set to something other than the default, and you have forgotten
the sequence, RMC must be reset to its factory settings to restore the default escape sequence.
___________________________ WARNING _________________________
The jumpers should only be set by service personnel who have the appropriate
technical training and experience. Installers should understand the hazards of
working within the system and take measures to minimize danger to
themselves or other personnel.
______________________________________________________________
___________________________ ACHTUNG _________________________
Die Jumper sollten nur von technischen Fachkräften mit der entsprechenden
technischen Schulung und Erfahrung eingestellt werden.
Installationstechniker sollten mit den mit der Arbeit in diesen Systemen
verbundenen Gefahren vertraut sein und entsprechende Maßnahmen zur
Minimierung der Gefahren für sich selbst und andere Personen einsetzen.
______________________________________________________________
Perform the following procedure to restore the default settings:
1. Perform a normal shutdown of the operating system and place the ON/Off button on the
OCP to the Off position.
2. Disconnect the power cord(s) from the power supplies. Wait until the +5V Aux LEDs on
the power supplies go off before proceeding.
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 4–15
Remote System Management