Removal and Replacement
5.7 Floppy Drive
Perform the following procedure to remove the floppy drive:
1. Extend the chassis for service (see Section 5.2).
2. Remove the front panel (see Section 5.3).
3. Remove the removable media bracket (see Section 5.6).
4. Remove the five screws
together (see Figure 5-6).
5. Disconnect the flex cable connector
6. Remove the four screws
media bracket (see Figure 5-6).
To replace the floppy drive, refer to Figure 5-6 and reverse steps 1 through 6 of the removal
procedure.
Figure 5-6 Removing and Replacing the Floppy Drive
1
5–8 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
c
that secure the two halves of the removable media bracket
from the rear of the floppy drive (see Figure 5-6).
that secure the floppy drive to the top half of the removable
3
1
3
2
EA-00082