Table of Contents
Advertisement
Table 4-1 Status Command Fields
Field
Meaning
On-Chip Firmware
Revision of RMC firmware on the microcontroller.
Revision:
Flash Firmware Revision:
Revision of RMC firmware in flash ROM.
Server Power:
On =System is on.
Off = System is off..
System Halt:
Asserted = System has been halted.
Deasserted = Halt has been released.
RMC Power Control:
On= System has powered on from RMC.
Off = System has powered off from RMC..
Escape Sequence:
Current escape sequence for access to RMC console.
Remote Access:
Enable = Modem for remote access is enabled.
Disable = Modem for remote access is disabled.
RMC Password:
Set = Password set for modem access.
Not set = No password set for modem access.
Alert Enable:
Enabled = Dial-out enabled for sending alerts.
Disabled = Dial-out disabled for sending alerts..
Alert Pending:
Yes = Alert has been triggered.
No = No alert has been triggered..
Init String:
Initialization string that was set for modem.
Dial String:
Pager string to be dialed when an alert occurs.
Alert String:
Identifies the system that triggered the alert to the paging service. Usually
the phone number of the monitored system.
Com1_mode:
Identifies the current COM1 mode..
Last Alert:
Type of alert (for example, fan problem).
Logout Timer:
The amount of time before the RMC terminates an inactive modem
connection. The default is 20 minutes.
User String:
Notes supplied by user.
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 4–9
Remote System Management
Advertisement
Table of Contents
Troubleshooting
