Table of Contents
Advertisement
2.4.2 Attaching the Slide Assemblies to the Cabin et Rails
The following sections contain the procedures for attaching the right and left slide assembles to
the cabinet rails.
2.4.2.1 Attaching the Right Slide Assembly to the Cabinet R ails
To attach the right slide assembly to the cabinet rails, refer to Figure 2-2 and proceed as
follows:
1. Determine the proper mounting holes for the right slide brackets. The proper mounting
holes are the 2nd, 3rd, 4th, and 5th holes of the installation area (see Figure 2-1).
2. Locate the right slide assembly and remove the inner race by extending the inner race to
the fully extended position and then pushing up on the locking lever and pulling the inner
race out of the slide assembly.
3. Place the right front slide bracket
of the captive bar nut with two slide bracket holes and with the 3rd and 5th holes of the
installation area on the right front rail.
4. Install two 10-32 screws
right front slide bracket to the right front rail, but do not tighten.
5. Place the right rear slide bracket
the captive bar nut with two slide bracket holes and with the 2nd and 4th holes of the
installation area on the right rear rail.
6. Install two 10-32 screws
right rear slide bracket to the right rear rail, but do not tighten.
7. Tighten the two 8-32 screws and nuts that secure the right rear slide bracket to the right
slide assembly.
8. Securely tighten all four 10-32 screws that secure the right slide assembly to the right front
and rear cabinet rails.
Figure 2-2 Attaching the Slide Assemblies to the Cabinet Rails
6
™
on the inside of the right front rail and align two holes
š
in the 3rd and 5th holes of the installation area to secure the
›
on the inside of the right rear rail and align two holes of
œ
in the 2nd and 4th holes of the installation area to secure the
7
5
10
2
Compaq ES40CSLP Rackmount System Installation/User/Service Guide 2–5
8
4
1
3
9
EA-00060
Installation
Advertisement
Table of Contents
Troubleshooting
