Removal and Replacement
5.18 PCI Card-Cage Fan Assembly
Perform the following procedure to remove the PCI card-cage fan assembly:
1. Extend the chassis for service (see Section 5.2).
2. Remove the hard disk drive cover (see Section 5.9).
3. Loosen the two captive screws
(see Figure 5-17).
4. Pull the fan assembly straight up to disconnect the power connector
assembly (see Figure 5-17).
5. Remove the power connector
(see Figure 5-17).
6. Remove the four screws
remove the fan (see Figure 5-17).
To replace the PCI card-cage fan and fan assembly, refer to Figure 5-17 and reverse steps 1
through 6 of the removal procedure.
Figure 5-17 Removing and Replacing the PCI Card-Cage Fan Assembly
5
5–20 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
c
that secure the top of the fan assembly
for the fan from the bottom of the fan assembly bracket
and nuts
that secure the fan to the fan assembly bracket and
4
1
2
3
to the chassis
on the bottom of the
EA-00089