Mounting The System On The Slides; Figure 2-4 Mounting The System On The Slides - Compaq ES40CSLP Installation, User & Service Manual

Installation

2.4.5 Mounting the System on the Slides

To mount the system on the slides, refer to Figure 2-4 and proceed as follows:
____________________________WARNING_________________________
The ES40CSLP rackmount system can weigh up to 40.82 kg (90 lb). Use
sufficient personnel or the proper lifting equipment when lifting or moving the
system.
______________________________________________________________
___________________________ ACHTUNG ________________________
Das ES40CSLP Rackmount System kann bis zu 40,82 kg (90 lb) wiegen. Beim
Hochheben oder Transport des Systems sollten deshalb genügend Hilfskräfte
vorhanden sein oder die richtigen Hebewerkzeuge benutzt werden.
______________________________________________________________
Stabilize the cabinet before installing the system into the cabinet.
1. Pull both equipment slides
2. Lift the chassis and position it so that the slide races
3. Push the system into the slides until it stops. Push up on the two locking levers
push the system into the cabinet.
4. Secure the system to the front cabinet rails using the four 10-32 captive screws
front panel. The captive screws go into the rail nuts
rails.

Figure 2-4 Mounting the System on the Slides

4
2–8 Compaq ES40CSLP Rackmount System Installation/User/Service Guide
™
out fully to their locked positions.
5
1
3
4
š
fit into the front end of the slides.

previously installed on the cabinet
5
2 1
EA-00062
›
and then
œ
on the