Ip406 Office - Rear View; Port Connections - Avaya IP Office Phone Installation Manual

Page 16 - IP406 Office - Rear View

IP406 Office - Rear View

Port connections

• External O/P Socket: Two relay ports that allow externally powered circuits to be
controlled via a single 3.5mm stereo jack socket.
• DC Power I/P Socket: Socket for the external 24V DC unregulated power supply
(supplied with kit).
• DTE Port: A 25-way D-type socket. Used for connection to PCs, servers and EFTPOS
terminals.
• BRI/PRI/ALOG Ports: The trunk interface modules are fitted into either Slots A or B
and can consist of any combination of:
- Quad Analog - 4 trunks (see page 35 for grounding)
- PRI E1/PRI E1-R2: 30 trunks
- PRI T1: 24B trunks or 23B+1D trunks (see page 35 for grounding)
- Quad BRI: 8 trunks.
PRI T1 trunks support both ISDN and Analog emulation. The default setting is 23B+1D
and is switchable in the installation software to provide 24B trunks.
See page 40 for installation, page 29 for country specific variants and page 35 for
grounding.
• WAN Port: This port supports a single synchronous data connection, which can be
X.21, V.35 or V.24. The selection of the required interface is automatically determined
from the pin-out of the cable plugged into the 'WAN' port. This cable must be
connected before power is applied for auto detection to work. Connection to a Digital
Leased Circuit is made by connecting the WAN port on the rear of the unit to the
existing Network Terminating Unit (NTU) via the appropriate X.21, V.35 or V.24 cable.
See pages 74, 75 and 76 for cable details and page 66 for port details. These
interfaces are identical to those on the WAN3 Extension Module (see page 26).
• Expansion Ports 1-6: Used to provide access to the optional Expansion Modules
(see page 23) which allow the IP406 Office to be expanded to 180 extensions (see
page 14).
• Audio I/P Socket: A single 3.5mm stereo or mono jack socket that enables input from
an external 'Music-on-Hold' source.
Port Pinouts and Cables
• For Port Pinouts and Cables, refer to pages 63 and 67 respectively.
Functional Earth
For Functional Earth connections see page 35.
Page 16 - IP406 Office Platform
IP406 Office - Rear View
DTE Port
DC Power I/P Socket
DC I/P
DTE
- C +
EXT
O/P
24V DC
2A
External O/P Socket
WAN Port
WAN
Slot A
Slots A and B can contain any combination of
ANALOG or BRI or PRI Trunk Modules
(Slot B must be used first)
ANALOG TRUNK BRI
1 2 3 4 1 2 3 4
40DHB0002USCL – Issue 9 (28th October 2003)
IP406 Office Platform
Expansion Ports 1-6
EXPANSION
1 2 3 4 5 6
AUDIO
Slot B
Audio I/P Socket
PRI
IP Office Installation Manual