Agilent Technologies E8362B Service Manual page 331

PNA Series Microwave Network Analyzers
E8362B, E8363B, E8364B
Figure 7-30 Hard Disk Drive Assembly Removal
Disassembling the HDDA
If the HDD is being replaced by the HDDA (N8980A or N8981A), it is not
NOTE
necessary to perform these steps.
Refer to Figure 7-31.
1. Remove the HDDA from the analyzer. Refer to
2. With a T-10 TORX driver, remove the four screws (item
②
(item ), that mount the HDD (item
3. Disconnect the HDD (item
Service Guide E8364-90026
"Removal Procedure" on page
④
), to the bracket.
④
) from the interface board (item
Repair and Replacement Procedures
Removing and Replacing the A41 Hard Disk Drive (HDD)
①
), and the eight bushings
③
).
7-62.
7-63