Proxim Tsunami Multipoint MP-820-BSU-100 Installation Manual page 75

3.3.3 Installation Procedure
This section describes the steps to install and mount the device(s).
: The device must be installed by a trained professional who is familiar with radio frequency planning and
regulatory limits.
Perform the following steps to install and mount the device.
Step 1: Plan for Installation
There are several planning factors to be considered before installing the device. In addition to selecting the installation site,
you should do the following:
Calculate:
Required RSL and fade margin to achieve link availability objectives. For more details on how to calculate RSL and fade
margin, please refer to the 'Antenna Installation Guide' and 'Proxim Link Calculator' that are available on the support
site at
Required path availability
Anticipated multi-path reflection points
Determine:
System frequency plan
Required transmission line types (like cable, waveguides) and lengths
Plan for:
Device's continuous power consumption needs
Lightning protection and system grounding
Hardware mounting
Cable installation including egress
Pre-testing equipment (back-to-back test procedure)
Step 2: Choose a Location
To make optimal use of the device, you must find a suitable location to install the hardware. Proxim recommends you do a site
survey, observing the following requirements, before mounting the hardware.
The location must allow easy disconnection of power to the radio, if necessary.
Ensure free flow of air around the hardware.
The radio device must be kept away from vibration and excessive heat.
The installation must conform to local regulations at all times.
Step 3: Gather Required Tools
You should have the following tools available before installing the device:
Cross-tip screwdrivers
Large blade standard screwdriver
Spanner 10
Wire crimpers (if using RJ45 connector that is not pre-made)
®
Tsunami 800 and 8000 Series - Hardware Installation Guide
.
8000 Series - Hardware Overview and Installation
75