Proxim Tsunami Multipoint MP-820-BSU-100 Installation Manual page 31

Please make a note of the Ethernet addresses, the MAC addresses and the serial number. These addresses may be
used when configuring the device. Note that the serial number helps you to seek support from the Proxim's Customer
support team.
Step 5: Pole Mount the Device
9. To pole-mount the device to a 1 inch diameter pole, place the mounting bracket with its small V-Groove facing the
pole (See option (1) in Figure 2).
10. To pole-mount the device to a 2.5 inch diameter pole, place the mounting bracket with its large V-Groove facing the
pole (See option (2) in Figure 2).
11. Place the device with its rear side facing the pole, and fasten the M8x80mm long screws along with the spring and
plain washers through the mounting bracket into the mounting holes of the device and tighten it to torque of 11
N.m/100 in-lbs.
Step 6: Plug in the Cables
: Unscrew the sealing cap for installation of the cable.
1. Weatherproofing RJ45 Connector:
a. Use a straight-through cable (Cat5/Cat5e or better) with one end bare.
b. Connect the crimped RJ45 connector end of the cable into the RJ45 Ethernet port inside the enclosure. The cable
connector should latch into the Ethernet port.
c. Slide the Flat Washer (A) into the Connector Body (B) to make it waterproof and onto the bare end of the cable.
Next, fasten the Connector Body into the Ethernet connector hole on the device.
d. Slide the tube-shaped Compression Washer (C) into the Compression Ring (D) and onto the cable from the bare
end, and insert into the fixed Connector Body.
e. Slide the Sealing Nut (E) over the bare end of the cable and fasten it on the fixed Connector Body.
f. Crimp the bare end of the cable with RJ45 connector and connect it to the LAN+DC port on the PoE Injector.
®
Tsunami 800 and 8000 Series - Hardware Installation Guide
800 Series - Hardware Overview and Installation
Figure 2-14 Pole-Mounting
31