Proxim Tsunami Multipoint MP-820-BSU-100 Installation Manual page 71
Tsunami 800 and 8000 series (point-to-point and point-to-multipoint products)
Hide thumbs
Also See for Tsunami Multipoint MP-820-BSU-100:
- Software management manual (170 pages) ,
- Hardware installation manual (91 pages)
Table of Contents
Advertisement
8000 Series - Hardware Overview and Installation
Antenna Alignment Commands
To enable the antenna alignment display from the CLI prompt, enter the following commands:
: Enables display of the local signal, noise and SNR.
: Enables display of the remote signal, noise and SNR.
: Enables display of local and remote signal, noise and SNR.
: Use a flat blade screw driver to disconnect and pull out the Serial cable from the enclosure after the antenna
alignment is done. After withdrawing the cables, seal the serial port carefully to avoid water seepage.
®
Tsunami
800 and 8000 Series - Hardware Installation Guide
71
Hide quick links:
Advertisement
Table of Contents
