Proxim Tsunami Multipoint MP-820-BSU-100 Installation Manual page 43

Step 11: View LEDs
When the device is powered on, it performs startup diagnostics. When startup is complete, the LEDs show the device's
operational status. The LEDs are available at the device's Ethernet connector inside the enclosure. You can see the LED
through the Ethernet connector. The LEDs will not be visible if the RJ45 connector is weatherproofed.
The following table describes the status of LED:
LED State
Off
Amber
Blinking Green
Solid Green
®
Tsunami 800 and 8000 Series - Hardware Installation Guide
Figure 2-26 LED Indicators
Power/Ethernet LED
No Power
No Application Image detected (ScanTool
mode)
Power is ON and the Ethernet link is DOWN
Power is ON and the Ethernet link is up
800 Series - Hardware Overview and Installation
Ethernet Interface
Radio is not present or failed to detect
Power is ON and device detects Reload signal
Radio is detected but wireless link has not
been established yet
Radio is detected and wireless link has been
established
Wireless LED
43